Renishaw Contact Tool Setter, Model TS27R
Feature
1. Proven kinematic design
2. Interference resistant hard-wired communication
3. Cost effective tool setting for all types of machining centres
4. 1.00 μm 2σ repeatability
Specification:
|
Principal application |
Tool measuring and broken tool detection on all sizes of vertical and horizontal machining centres and all gantry machining centres. |
|
|
Transmission type |
Hard-wired transmission |
|
|
Compatible interfaces |
MI 8-4, HSI or HSI-C |
|
|
Recommended styli |
Disc stylus (tungsten carbide, 75 Rockwell C) or Square tip stylus (ceramic tip, 75 Rockwell C) |
|
|
Weight with disc stylus |
1055 g (37.21 oz) |
|
|
Cable (to interface) |
Specification |
Ø4.35 mm (0.17 in), 4-core screened cable, each core 7 x 0.2 mm |
|
Length |
10 m (32.8 ft) |
|
|
Electrical connection |
Cable on the end of unit |
|
|
Sense directions |
±X, ±Y, +Z |
|
|
Unidirectional repeatability |
1.00 μm (40 μin) 2σ (note 1) |
|
|
Stylus trigger force (notes 2 and 3) |
1.30 N to 2.40 N, 133 gf to 245 gf (4.68 ozf to 8.63 ozf) depending on sense direction |
|
|
Sealing |
IPX8 (EN/IEC 60529) |
|
|
Mounting |
M12 (1/2 in) T bolt (not supplied) Optional Spirol pins to allow accurate remounting |
|
|
Operating temperature |
+5 °C to +55 °C (+41 °F to +131 °F) |
|
Note 1: Performance specification is tested at a standard test velocity of 480 mm/min (18.9 in/min) with a 35 mm stylus. Significantly higher velocity is possible depending on application requirements.
Note 2: Rigger force, which is critical in some applications, is the force exerted on the component by the stylus when the probe triggers. The maximum force applied will occur after the trigger point (overtravel). The force value depends on related variables including measuring speed and machine deceleration.
Note 3: These are the factory settings; manual adjustment is not possible.










